Goodtime Banjo Piezo Pickup Installation

1.The banjo piezo film pickup will go on the underside of the head, parallel to the bridge. Remove the film covering one side of the pickup and place the pickup under the head and parallel to the bridge.

2.You will have to drill a hole in the rim to accommodate the pickup jack installation whether you have an openback or resonator model. 

3. Unscrew the end and remove all the washers and the hex nut.

4. Put the pickup through the hole.

5.You will need to determine how many of the washers you replace to get a snug fit on the jack before you replace the hex nut back in place.

6. You do not want it to rotate. It may mean a bit of experimentation…and it may be you will only need to use only the largest washer to place over the end then screw on the hex nut. Screw the end cap in place. Done!!

7.The installation is pretty basic. Call our toll free number if you have any questions.